The first thing happened a few days ago, after freewheeling down a 2 mile slope a warning light came on saying " acceleration limited" and the car was unresponsive to accelerator but driveable. next day it briefly would not start and the " Engine Malfunction" light came on.
2014 2.0 tdci ford focus..driving it down motorway yesterday and it popped up on the dash Engine Malfunction Sercive Now. The engine management light isn't on, no power loss or anything. Only the little box with 'i' is lit up. I have plugged in 2 OBD reader's and they have shown no codes. The light you are showing (looks a bit like an engine block to me, not sure if its meant to) is a general engine malfunction warning according to the handbook, "go immediately to a ford dealer and get ripped off big bucks to have it reset". Hello I have a ford focus 1.6 Ti-VCT 2009. Yesterday i drove back from work about 5-6km when suddenly the beeper started to beep, car gauges suddenly sweeps (I was driving with 100km/h), many leds at dash was light up and there was the "Engine malfunction" message at dash .Ford Focus 2 Facelift 1.6Tdci 110Cp 2009 Settings. In this video, I'll show you how to reset the Engine Malfunction Warning Message on my 09 Ford Focus. This simple procedure is similar to oneChanged the fuel filter on my 1.6 tdci focus , (the filter with the module on top ) I've filled the filter with diesel , used a Home made fuel primer to get the fuel to come through the lines. However no fuel seems to come from the common rail injector nuts when loosened off. Hi Botus, I have since fitted a new Crank & Cam Sensor today but no improvement. However I reconnected the battery and went driving with the new parts as mentioned above this morning, The "engine system" flickered on and went off again and for some reason I tapped the top of the dash and the "engine system" light went out! LlT9k.